Britain blue (original American great lake) Floclean MC3 cleansing agent

Product characteristic:

Floclean MC3 is one low pH formula, designed especially uses in eliminating the hydrogenium oxide compound, the calcium carbonate specially and other similar adheres to stick cohere is gathering the amide, the polysulphone and the thin film component membrane surface filth. This kind of high efficiency's powder has the following characteristic:

●PH3.0 ± 0.5 adopts adjustable,

●At room temperature; adopts high

●It had not include surfactants, easy washing,

●Contain organic acid, detergents and chelating agent.

Floclean MC3 is applicable to all polyamide, and thin film components. It applies to the film producers from 15 degrees recommended maximum temperature. The standard is attenuant rate Floclean 25 grams in 1 liter MC3.

Cleaning:

▼ check wash tank, line and the security filter. Install the new filter.

▼ will join the reverse osmosis water to wash tank.

▼ Add 1 liter water 25 grams of Floclean MC3 add ratio.

▼ with mixer or cleaning pump cycle solution to thoroughly mix cleaning solution.

▼ solution can be heated to strengthen cleaning effect.

▼ do not exceed film producers temperature limits.

▼ with film producers or system manufacturers recommend flow from the same direction into circulation water solution for 1 hour. If not, the following guidelines recommend manufacturer can be used as a reference.

Roll film

Membrane diameter (inch) each membrane tube's speed of flow (and current of water parallel) l/min (US gallon/minute)

4               23(6)

6               53(14)

8               91(24)

10              144(38)

12              204(54)

Hollow fiber membrane

Membrane diameter (inch) each membrane tube's speed of flow (and current of water parallel) l/min (US gallon/minute)

4                19(5)

8                57(15)

10               76(20)

◆A severe case fouling, initial backflow of cleaning tank (15%) should drain capacity, in order to prevent the solid again already removed.

◆Aiming at multiple systems,it will be best if every level cleaning effect system alone.

◆If in the cleaning solution should become turbid or color should drain. In each class should be cleaned before the system configuration of new solution.

◆Aiming at the system to start with water before should be cleaned thoroughly.

Our company acts the British blue industrial chemical&US big lake water finishing agent each serial products:

Scale inhibitor: Flocon260、Flocon135 、Flocon150、FloconPlus、Flocon220、Flocon295、Flocon285、Flocon190

Cleansing agent: Floclean MC3、 Floclean MC11、Floclean MC10、Floclean MC15、Floclean MC20、Floclean MC25、Floclean MC30、Floclean MC50

Disinfectant: Flocide380